PDA

View Full Version : General Tech Questions

  1. Welcome to the Information Age!
  2. ADI Pilot II/Autopilot Master switch
  3. Pre-wired harness
  4. Max capture angle
  5. RS485
  6. RF Issue - possible resolution
  7. Digiflight IIVSGV
  8. GPS1 / GPS2 Switch
  9. Wiring questions
  10. RF interference question
  11. Connection to GPS
  12. Latest firmware rev for the Sorcerer?
  13. How to charge the Trutak backup battery PN 8220-009?
  14. No Workie!
  15. Bank Angle limitations
  16. RV-8 Roll Servo Bracket
  17. Serial Connection on VSGV
  18. Digitrak debugging advice needed
  19. Operational questions
  20. Pitch control problems
  21. Autotrim
  22. Locking onto a route.
  23. Need advice for porpoising
  24. Turning off Alt mode
  25. rocking with OP technologies EFIS
  26. jrouault's GPSV Problem
  27. garmin 496
  28. Problem with other vendors equipment
  29. Pitch servo installation in RV-7A -- old problem, new solution?
  30. Pitch problems - Digiflight IIVS
  31. Leaking Connector Block?
  32. FAQ
  33. GPSS not available
  34. wrong servo?
  35. Trutrak Live Support
  36. ADI Battery Backup Connections
  37. Garmin 295 input to ADI Pilot I
  38. Ratcheting?
  39. New ARINC Module
  40. Altitude Hold no holding
  41. Digitrak power interuption
  42. F,,,,,ing
  43. ALT LED blinks but will not light up when pressed
  44. Servo Screws
  45. Noise in headset
  46. Autotrim setup
  47. Which wire?
  48. gps496, gns430 with older digiflight 200VS
  49. ADI backup battery melt down
  50. RV8 Roll Servo Bracket - install problem
  51. COM Antenna & Coax to AP Servos Proximity?
  52. Wiring Autotrim
  53. GPSV mode stopped working
  54. Pictorial Turn & Bank
  55. TruTrak, Garmin 396, and Dynon D180 Interface
  56. Aileron oscillations
  57. No GPSS after Garmin 430 WAAS upgrade
  58. Can not get astrick with Garmin 430
  59. DigiflightII VS vs Digiflight 200 VS
  60. Minimum Speed
  61. Doesn't maintain altitude in turbulence
  62. What setting do most RV-7's use
  63. Sorcerer Software
  64. LS Display instead of GPSS
  65. II VSGV Failover Sequence question
  66. Servo harness/comm coax/strobes