|
|
#1
01-17-2010, 07:34 AM
|
|||
|
|||
senders
Hello
does the Trutrack fuel pressure sender allow to measure pressure until 4 to 5 bars (75 PSI) because my new injection engine UL POWER is using a normal fuel pressure of 3 to 3.5 bars for run . So I need to be sure that the maximun range of the trutrack is ok ; these senders are they done for fuel ? I mean reliable for years!!: with steel "membranne" and approved seals!! I apologise these question but the picture of this sender (in the installation manual) seems to show something similar to a VDO sender!!! And I absolutly do not want this trademark for that purpose !!!!!! Is there an 5/8 -18 thread oiltemp sensor existing and what part number Is there an 10 X 100 thread oil pressure sensor exiting and what part number Many thanks for help 
|
|
#2
01-19-2010, 06:41 PM
|
||||
|
||||
|
Michel,
The injected engine fuel pressure sensor we use will read up to 5 bars. To be honest, I'm not sure of the thread size as I'm out of the office at this time. I will get that information and post back here. Thanks!
__________________
Lucas Trutrak Tech Support
|
|
#3
01-20-2010, 05:36 AM
|
|||
|
|||
|
Does a UMA fuel pressure sender will work also (I have one already installed in the pressure line)
OK thanks for your help I appreciate !!for the others oil senders info I will wait about your information
|
|
#4
01-26-2010, 12:29 PM
|
||||
|
||||
|
The only fuel pressure sensors we have calibrated for are made by VDO. We do not have a calibration map for UMA sensor at this time.
The oil pressure sensors we have use a 1/8"-27 thread and the oil temperature sensors we have use a 5/8"-18 thread. I hope this helps. Thanks!
__________________
Lucas Trutrak Tech Support
|
|
#5
01-27-2010, 02:23 AM
|
|||
|
|||
|
Ok thanks for info
I place an order to my french suplier . I have some doubt about reliability of VDO sensor in fuel lines!!! Can you confirm I will not have leak trouble at 3 bar after 50 or 100 Hrs running ? I will be more confident reading Trutrack expertise for that particular point!! Are these VDO sensor built for this application( I mean fuel environnement) ? apologise for insisting but a bad experience push me in asking this!! Merci bien
|
|
#6
01-27-2010, 07:13 AM
|
||||
|
||||
|
We have always used the VDO fuel pressure sensors. They are made specifically for that application and we've never had any trouble from them. Thanks!
__________________
Lucas Trutrak Tech Support
|
 |
| Thread Tools | Search this Thread |
|
|
